OpenWrt/LEDE Project

Welcome to the OpenWrt/LEDE Project bug reporting and issue tracking system

Problems to be reported here are for the OpenWrt/LEDE Project targets, sources, toolchain, core packages, build procedures, distribution and infrastructure. Guidelines for submitting a good bug report can be found at the OpenWrt/LEDE Project website. Problems related to LuCI or OpenWrt packages need to be reported in their repositories:

Notifications of all submissions and task changes are sent to lede-bugs@infradead.org.

OpenedIDCategoryTask TypePrioritySeveritySummaryReported InStatus
16.05.20203100Base systemBug ReportVery LowLowminiupnpd.conf generated by /etc/init.d/miniupnpd uses ...openwrt-19.07Unconfirmed Task Description

- Software versions of OpenWrt/LEDE release, packages, etc.

  • OpenWrt 19.07.2, r10947-65030d81f3
  • miniupnpd - 2.1.20191006-4

I have both native IPv6 (wan_6 virtual interface from pppoe) and 6to4. I need 6to4 to connect to other 6to4 peers which is faster than native IPv6 (and sometimes native IPv6 cannot reach 6to4). /var/etc/miniupnpd.conf generated by /etc/init.d/miniupnpd uses 6to4 instead of native IPv6, the file contains the following lines

ext_ifname=pppoe-wan
ext_ifname6=6to4-wan6

I think it’s better to use native IPv6 interface by default.
Additionally, is it possible to add ipv6_disable option to the config? Buggy UPnP clients sometimes put IPv6 address in a IPv4 port mapping request, I’d like to check if disabling IPv6 UPnP would fix it, this problem is mentioned in https://github.com/miniupnp/miniupnp/issues/408

06.02.2017472Base systemBug ReportVery LowMedium6to4 support with 1:1 natTrunkWaiting on reporter Task Description

One-to-one NAT means you have LAN address on interface and its mapped 1:1 to external ip addresses.
You can have incoming connections.

In such configuration “ipaddr” must be specified in 6to4 protocol section.
But due to bug this addr is submitted as local address for tunnel creation.
It does not work.

I fixed this with the following patch to /lib/netifd/proto/6to4.sh

48,53c48,53
< [ -z “$ipaddr” ] && {
< if ! network_get_ipaddr ipaddr “$wanif”; then
< proto_notify_error “$cfg” “NO_WAN_ADDRESS” < return
< fi
< }

if ! network_get_ipaddr ipladdr “$wanif”; then
> proto_notify_error “$cfg” “NO_WAN_ADDRESS”
return
> fi
>
> [ -z “$ipaddr” ] && ipaddr=$ipladdr
76c76
< json_add_string local “$ipaddr”

json_add_string local “$ipladdr”

I suggest you integrate this patch or do something similar yourself.

Showing tasks 1 - 2 of 2 Page 1 of 1

Available keyboard shortcuts

Tasklist

Task Details

Task Editing