OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Dave Täht - 04.02.2017

FS#463 - up/down on a usbnet interfaces fails to reassign ULA addresses

Supply the following if possible:
- Device problem occurs on: anything running usbnet
- Software versions of LEDE release, packages, etc: head
- Steps to reproduce:

Install the usbnet package, enable a usb0 device in /etc/config/network

(in my case this is a c.h.i.p, but most hackerboards except the pi do usbnet)

config interface ‘usb0’

      option ifname 'usb0'            
      option proto 'static'                 
      option ipaddr '172.26.97.200'
      option netmask '255.255.255.255'
      option ip6assign '64'           
      option ip6class 'local' 

So long as the chip beats the router to booting, this gives it an ipv4 and ipv6 ULA out of the pool.

Reboot the device on the other side. The kernel deregisters and registers the usbnet driver, and netifd assigns the ipv4 address again.

However the ip6 subnet that was assigned from the ula does not come back. Haven’t tried it with a public address.

ifup/ifdown does not work and the ifstatus usb0 does not show any ipv6 addresses assigned.

Dave Täht commented on 04.02.2017 21:51

ifdown/ifup (does not reassign the ipv6 addr), to clarify.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing