We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
dtaht:
Supply the following if possible:
Install the usbnet package, enable a usb0 device in /etc/config/network
(in my case this is a c.h.i.p, but most hackerboards except the pi do usbnet)
config interface 'usb0' option ifname 'usb0' option proto 'static' option ipaddr '172.26.97.200' option netmask '255.255.255.255' option ip6assign '64' option ip6class 'local'
So long as the chip beats the router to booting, this gives it an ipv4 and ipv6 ULA out of the pool.
Reboot the device on the other side. The kernel deregisters and registers the usbnet driver, and netifd assigns the ipv4 address again.
However the ip6 subnet that was assigned from the ula does not come back. Haven't tried it with a public address.
ifup/ifdown does not work and the ifstatus usb0 does not show any ipv6 addresses assigned.
The text was updated successfully, but these errors were encountered:
ifdown/ifup (does not reassign the ipv6 addr), to clarify.
Sorry, something went wrong.
No branches or pull requests
dtaht:
Supply the following if possible:
Install the usbnet package, enable a usb0 device in /etc/config/network
(in my case this is a c.h.i.p, but most hackerboards except the pi do usbnet)
config interface 'usb0'
option ifname 'usb0'
option proto 'static'
option ipaddr '172.26.97.200'
option netmask '255.255.255.255'
option ip6assign '64'
option ip6class 'local'
So long as the chip beats the router to booting, this gives it an ipv4 and ipv6 ULA out of the pool.
Reboot the device on the other side. The kernel deregisters and registers the usbnet driver, and netifd assigns the ipv4 address again.
However the ip6 subnet that was assigned from the ula does not come back. Haven't tried it with a public address.
ifup/ifdown does not work and the ifstatus usb0 does not show any ipv6 addresses assigned.
The text was updated successfully, but these errors were encountered: