Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

FS#4177 - 21.02.1 factory image not working on GL.Inet E750 Mudi #9158

Open
openwrt-bot opened this issue Dec 6, 2021 · 2 comments
Open
Labels
flyspray release/21.02 pull request/issue targeted (also) for OpenWrt 21.02 release

Comments

@openwrt-bot
Copy link

Tranquility76:

Device: GL.Inet E750 Mudi
OpenWRT: openwrt-21.02.1-ath79-nand-glinet_gl-e750-squashfs-factory.img

After flashing the device with UBOOT the reboot occurs. The display shows "Booting..." and the status bar is moving until around 90%. At this point it stops and the boot process never ends and the device is not usable any more. Turning off/on does not help.

Reverting to the original GL.Inet firmware via UBOOT makes the device working again. (Hint: The original firmware also stops at around 90% of the boot process for a minute or so but goes on after that.)

@aparcar aparcar added the release/21.02 pull request/issue targeted (also) for OpenWrt 21.02 release label Feb 22, 2022
@landoncolburn
Copy link

If you didn’t figure this out yet, I believe the issue is actually that it worked. Try navigating to 192.168.1.1 and you’ll most likely be presented with the LuCI GUI. I’m assuming the firmware just isn’t updating the screen on the device. Let me know if this helps!

@TacoAndBurrito
Copy link

This is also a problem on my E750. Functions fine, but the OLED shows Booting and stuck at 90% or 4 dots.

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
flyspray release/21.02 pull request/issue targeted (also) for OpenWrt 21.02 release
Projects
None yet
Development

No branches or pull requests

4 participants