You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Download sysupgrade image, openwrt-21.02.0-mvebu-cortexa9-linksys_wrt1900acs-squashfs-sysupgrade.bin from [[https://openwrt.org/toh/linksys/wrt1900acs|Linksys WRT1900acs page]]. SHA256: 3880d91cdc54e1cb88cdb3123244d5cf85b8a05d64b4206fb0bd6462a6c73f49
In LuCi interface, go to "Backup / Flash Firmware" page and upload file in the "Flash new Firmware Image" box.
Get the warning.
Warning Text:
"Device linksys,shelby not supported by this image Supported devices: linksys,wrt1900acs armada-385-linksys-shelby linksys,shelby - Image version mismatch: image 1.1, device 1.0. Please wipe config during upgrade (force required) or reinstall. Reason: Config cannot be migrated from swconfig to DSA Image check failed.
The uploaded image file does not contain a supported format. Make sure that you choose the generic image format for your platform."
The text was updated successfully, but these errors were encountered:
I have found information about this warning on the [[https://openwrt.org/releases/21.02/notes-21.02.0|release notes for 21.02.0]]. So would the best course of action be to do a fresh install of 21.02.0 and set up my configuration again from scratch?
ianmtaylor1:
Device:
Model: Linksys WRT1900ACS
Architecture: ARMv7 Processor rev 1 (v7l)
Software versions:
Firmware Version: OpenWrt 19.07.7 r11306-c4a6851c72 / LuCI openwrt-19.07 branch git-21.044.30835-34e0d65
Kernel Version: 4.14.221
Steps to reproduce:
openwrt-21.02.0-mvebu-cortexa9-linksys_wrt1900acs-squashfs-sysupgrade.bin
from [[https://openwrt.org/toh/linksys/wrt1900acs|Linksys WRT1900acs page]]. SHA256:3880d91cdc54e1cb88cdb3123244d5cf85b8a05d64b4206fb0bd6462a6c73f49
Warning Text:
"Device linksys,shelby not supported by this image Supported devices: linksys,wrt1900acs armada-385-linksys-shelby linksys,shelby - Image version mismatch: image 1.1, device 1.0. Please wipe config during upgrade (force required) or reinstall. Reason: Config cannot be migrated from swconfig to DSA Image check failed.
The uploaded image file does not contain a supported format. Make sure that you choose the generic image format for your platform."
The text was updated successfully, but these errors were encountered: