OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Ian Taylor - 08.09.2021

FS#4015 - Linksys WRT1900ACS sysupgrade image for 21.02.0 shows warning after upload


Model: Linksys WRT1900ACS
Architecture: ARMv7 Processor rev 1 (v7l)

Software versions:

Firmware Version: OpenWrt 19.07.7 r11306-c4a6851c72 / LuCI openwrt-19.07 branch git-21.044.30835-34e0d65
Kernel Version: 4.14.221

Steps to reproduce:

  1. Download sysupgrade image,

    from Linksys WRT1900acs page. SHA256:

  2. In LuCi interface, go to “Backup / Flash Firmware” page and upload file in the “Flash new Firmware Image” box.
  3. Get the warning.

Warning Text:

“Device linksys,shelby not supported by this image Supported devices: linksys,wrt1900acs armada-385-linksys-shelby linksys,shelby - Image version mismatch: image 1.1, device 1.0. Please wipe config during upgrade (force required) or reinstall. Reason: Config cannot be migrated from swconfig to DSA Image check failed.

The uploaded image file does not contain a supported format. Make sure that you choose the generic image format for your platform.”

Ian Taylor commented on 08.09.2021 05:10

Apologies for not setting the severity and reported version, I did not see those options until too late.

Ian Taylor commented on 08.09.2021 05:32

I have found information about this warning on the release notes for 21.02.0. So would the best course of action be to do a fresh install of 21.02.0 and set up my configuration again from scratch?

anomeome commented on 08.09.2021 17:30


Available keyboard shortcuts


Task Details

Task Editing