You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Only /dev/sda now is present and this device is not block device and cant be mounted.
After physical reconnection of SSD it is working again, /dev/sda1, /dev/sda2 etc. are visible and mounted properly.
Any ideas how to fix it?
The text was updated successfully, but these errors were encountered:
OpenWrt 19.07 release is EOL, try to reproduce the issue with latest supported release and feel free to ask for issue reopening if the problem is still present, thanks.
RCherepanov:
Supply the following if possible:
Install:
root@OpenWrt:~# opkg list-installed | grep usb
kmod-usb-core - 5.4.143-1
kmod-usb-ehci - 5.4.143-1
kmod-usb-ledtrig-usbport - 5.4.143-1
kmod-usb-ohci - 5.4.143-1
kmod-usb-ohci-pci - 5.4.143-1
kmod-usb-storage - 5.4.143-1
kmod-usb-storage-extras - 5.4.143-1
kmod-usb-storage-uas - 5.4.143-1
kmod-usb-uhci - 5.4.143-1
kmod-usb-xhci-hcd - 5.4.143-1
kmod-usb-xhci-mtk - 5.4.143-1
kmod-usb2 - 5.4.143-1
kmod-usb2-pci - 5.4.143-1
libusb-1.0-0 - 1.0.24-4
libusb-compat4 - 0.1.7-2
usb-modeswitch - 2017-12-19-f40f84c2-2
reboot.
Connect portable SSD to USB port. SSD is working fine.
[ 62.313822] sd 0:0:0:0: [sda] 250069680 512-byte logical blocks: (128 GB/119 GiB)
[ 62.321654] sd 0:0:0:0: [sda] Write Protect is off
[ 62.326429] sd 0:0:0:0: [sda] Mode Sense: 47 00 00 08
[ 62.326752] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 62.343033] sda: sda1 sda2 sda3
[ 62.350420] sd 0:0:0:0: [sda] Attached SCSI disk
[ 63.881045] EXT4-fs (sda3): mounted filesystem with ordered data mode. Opts:
Reboot device
SSD is found, but not respondig till manual reconnection.
root@OpenWrt:~# dmesg | grep sd
[ 16.043325] sd 0:0:0:0: [sda] Unit Not Ready
[ 16.047611] sd 0:0:0:0: [sda] Sense Key : 0x5 [current]
[ 16.053015] sd 0:0:0:0: [sda] ASC=0x20 ASCQ=0x0
[ 16.059685] sd 0:0:0:0: [sda] Read Capacity(10) failed: Result: hostbyte=0x00 driverbyte=0x08
[ 16.068317] sd 0:0:0:0: [sda] Sense Key : 0x5 [current]
[ 16.073712] sd 0:0:0:0: [sda] ASC=0x20 ASCQ=0x0
[ 16.078380] sd 0:0:0:0: [sda] 0 512-byte logical blocks: (0 B/0 B)
[ 16.084586] sd 0:0:0:0: [sda] 0-byte physical blocks
[ 16.090260] sd 0:0:0:0: [sda] Write Protect is off
[ 16.095083] sd 0:0:0:0: [sda] Mode Sense: 00 00 00 00
[ 16.095607] sd 0:0:0:0: [sda] Asking for cache data failed
[ 16.101184] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 16.110377] sd 0:0:0:0: [sda] Unit Not Ready
[ 16.114695] sd 0:0:0:0: [sda] Sense Key : 0x5 [current]
[ 16.120068] sd 0:0:0:0: [sda] ASC=0x20 ASCQ=0x0
[ 16.126769] sd 0:0:0:0: [sda] Read Capacity(10) failed: Result: hostbyte=0x00 driverbyte=0x08
[ 16.135355] sd 0:0:0:0: [sda] Sense Key : 0x5 [current]
[ 16.140717] sd 0:0:0:0: [sda] ASC=0x20 ASCQ=0x0
[ 16.146232] sd 0:0:0:0: [sda] Attached SCSI disk
[ 17.279150] usbcore: registered new interface driver ums-isd200
[ 17.302647] usbcore: registered new interface driver ums-sddr09
[ 17.310530] usbcore: registered new interface driver ums-sddr55
Only /dev/sda now is present and this device is not block device and cant be mounted.
After physical reconnection of SSD it is working again, /dev/sda1, /dev/sda2 etc. are visible and mounted properly.
Any ideas how to fix it?
The text was updated successfully, but these errors were encountered: