You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Plug WAN port with two-pair cable of an ISP (100Mb/s)
Execute cmd: ethtool wan
Speed: 1000Mb/s
Duplex: Full
The connection is not working due to the incorrect speed.
Connect the same cable to a switch, and then the router to the same switch. Or execute the command: ethtool -s wan speed 100 autoneg off duplex full
After that the connection is properly established with proper speed: ethtool wan
Speed: 100Mb/s
Duplex: Full
Autonegotiation was working properly about a year and a half ago, so there was some changes made in the code that affected it. It also working with no issue with stock firmware.
The text was updated successfully, but these errors were encountered:
Technocrat:
Supply the following if possible:
Execute cmd:
ethtool wan
Speed: 1000Mb/s
Duplex: Full
The connection is not working due to the incorrect speed.
Connect the same cable to a switch, and then the router to the same switch. Or execute the command:
ethtool -s wan speed 100 autoneg off duplex full
After that the connection is properly established with proper speed:
ethtool wan
Speed: 100Mb/s
Duplex: Full
Autonegotiation was working properly about a year and a half ago, so there was some changes made in the code that affected it. It also working with no issue with stock firmware.
The text was updated successfully, but these errors were encountered: