OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Technocrat - 22.08.2021

FS#3986 - Autonegotiation stopped working

Supply the following if possible:
- Device problem occurs on ASUS RT-AC65P
- Software versions of OpenWrt 21.02.0-rc3
- Plug WAN port with two-pair cable of an ISP (100Mb/s)
Execute cmd:

ethtool wan

Speed: 1000Mb/s
Duplex: Full
The connection is not working due to the incorrect speed.

Connect the same cable to a switch, and then the router to the same switch. Or execute the command:

ethtool -s wan speed 100 autoneg off duplex full


After that the connection is properly established with proper speed:

ethtool wan

Speed: 100Mb/s
Duplex: Full

Autonegotiation was working properly about a year and a half ago, so there was some changes made in the code that affected it. It also working with no issue with stock firmware.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing