OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Kernel
  • Assigned To No-one
  • Operating System All
  • Severity Critical
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Dirk Chang - 20.07.2021

FS#3941 - Banana Pi M2 Ultra follow in endless rebooting with latest snapshot image

Supply the following if possible:
- Device problem occurs on
- Software versions of OpenWrt/LEDE release, packages, etc.
- Steps to reproduce

 

Device: Banana Pi M2 Ultra
OpenWrt: Snapshot image from https://downloads.openwrt.org/snapshots/targets/sunxi/cortexa7/ Steps:

1. uncompressed downloaded file
2. dd to TF card
3. Put this TF card into board’s TF slot
4. Using usb-serial converter connects to its debug uart pins
5. Power on M2U board
6. Watch the boot log

  [    1.376746] libphy: stmmac: probed
  [    1.389128] mmc1: queuing unknown CIS tuple 0x80 (2 bytes)
  [    1.394664] mmc0: host does not support reading read-only switch, assuming write-enable
  [    1.402844] mmc0: new SDHC card at address 0001
  [    1.408341] mmcblk0: mmc0:0001 SD8GB 7.28 GiB 
  [    1.414442] mmc1: queuing unknown CIS tuple 0x80 (3 bytes)
  [    1.419981]  mmcblk0: p1 p2
  [    1.426302] mmc1: queuing unknown CIS tuple 0x80 (3 bytes)
  [   
  U-Boot SPL 2020.04 (Jul 20 2021 - 03:16:48 +0000)
  DRAM: 2048 MiB
  Trying to boot from MMC1

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing