New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
FS#3860 - bcm53xx: Image Builder fails with "os-image partition too big" on Netgear R8000 #8879
Comments
NautilusChan: the whole message as below:
|
bjonglez: The error is "os-image partition too big (more than 2097152 bytes)" Release builds seem to build fine for this board, are you adding or changing something in the imagebuilder? Can you check that release builds actually work on the board? |
NautilusChan: I do nothing with the imagebuilder. |
NautilusChan: I had tried to do the same opeartions with v19.07.05. There was just a warining message:
|
NautilusChan:
I use the Image Builder to build image for my NETGEAR R8000.
Firstly, I tried to build with the command which I had use many times in 19.07.03.But I got error message like this:
WARNING: maxlen exceeds default maximum! Beware of overwriting nvram!
os-image partition too big (more than 2097152 bytes): Success
make[3]: *** [Makefile:456: /media/nautilus/Data/Personal/Router/openwrt/21.02-RC2/openwrt-imagebuilder-21.02.0-rc2-bcm53xx-generic.Linux-x86_64/build_dir/target-arm_cortex-a9_musl_eabi/linux-bcm53xx_generic/tmp/openwrt-21.02.0-rc2-bcm53xx-generic-tplink_archer-c5-v2-squashfs.bin] Error 1
make[2]: *** [Makefile:186: build_image] Error 2
make[1]: *** [Makefile:124: _call_image] Error 2
make: *** [Makefile:240: image] Error 2
Then, I use the default command like this:
make image PROFILE=netgear_r8000
But I got the same error message.
I can't get any useful message from the error message. And I can build image successfully with v19.07.03. That means the envirment is well.
The text was updated successfully, but these errors were encountered: