You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Software versions of OpenWrt/LEDE release, packages, etc.
Steps to reproduce
I cannot connect to 801.x (WPA2 Enterprise) configured with EAP after upgraded to trunk 53b9cc4. The FreeRadius server debug run into errors as
Receive - Malformed RADIUS packet from host 192.168.1.2: Invalid attribute 0
which I never encountered before the upgrading.
BTW, my FreeRadius server is running in another Ubuntu host (untouched), and 192.168.1.2 is the AP's ip address.
My AP is a D-Link DIR-860L B1, running trunk snapshot build, removed wpad-basic-wolfssl and installed wpad package for 801.x WiFi authentication.
This issue just appeared after the upgrading, previous 1 or 2 snapshots (May 25) is working just fine.
Reported on the OpenWRT forum as the attached link.
The text was updated successfully, but these errors were encountered:
Enig123:
Supply the following if possible:
I cannot connect to 801.x (WPA2 Enterprise) configured with EAP after upgraded to trunk 53b9cc4. The FreeRadius server debug run into errors as
Receive - Malformed RADIUS packet from host 192.168.1.2: Invalid attribute 0
which I never encountered before the upgrading.
BTW, my FreeRadius server is running in another Ubuntu host (untouched), and 192.168.1.2 is the AP's ip address.
My AP is a D-Link DIR-860L B1, running trunk snapshot build, removed wpad-basic-wolfssl and installed wpad package for 801.x WiFi authentication.
This issue just appeared after the upgrading, previous 1 or 2 snapshots (May 25) is working just fine.
Reported on the OpenWRT forum as the attached link.
The text was updated successfully, but these errors were encountered: