You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
There is a solution, just set wireless from uci commands.
uci set wireless.radio0.disabled='0'
uci set wireless.radio0.hwmode='11g'
uci set wireless.radio0.htmode='HT20'
uci set wireless.radio0.cell_density='0'
uci set wireless.radio0.country='US'
uci set wireless.radio0.channel='3'
uci set wireless.radio1.hwmode='11a'
uci set wireless.radio1.htmode='VHT80'
uci set wireless.radio1.disabled='0'
uci set wireless.radio1.cell_density='0'
uci set wireless.radio1.country='US'
uci set wireless.radio1.channel='36'
uci commit wireless
wifi
conan92:
Device: ramips/mt7621/GL-MT1300
OpenWrt lastest trunk version, with luci installed.
In wireless, when N mode is selected, there is no 2.4G/5G switching option and cannot be set to 2.4G.
After modifying the /etc/config/wireless file, the following errors are reported in the system log.
Sun Apr 4 21:49:15 2021 daemon.notice hostapd: Configuration file: /var/run/hostapd-phy0.conf (phy wlan0)
Sun Apr 4 21:49:15 2021 daemon.err hostapd: Interface name wlan0 already in use
Sun Apr 4 21:49:15 2021 daemon.notice netifd: radio0 (10727): Command failed: Invalid argument
Sun Apr 4 21:49:15 2021 daemon.notice netifd: radio0 (10727): Device setup failed: HOSTAPD_START_FAILED
Sun Apr 4 21:49:15 2021 daemon.notice netifd: radio0 (10816): WARNING: Variable 'data' does not exist or is not an array/object
The text was updated successfully, but these errors were encountered: