You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
ath79: CPE2xx, CPE5xx, maybe a major - think other devices too.
OpenWrt 19.07 - Steps to reproduce:
Bug is reproducible:
(for measurement did logout LuCI, then ssh & top)
Freifunk images -> after FFwizard+reboot -> CPU ~35%
-> set rssi (default: wlan0) to wlan0-dhcp2 or wlan0-mesh-2 in /etc/config/system -> CPU ~5%
Openwrt stock (19.07.7), firstboot, wifi:
-> AP disabled (default setting) -> CPU ~2%
-> AP enabled -> CPU ~4%
!!! -> AP disabled again -> CPU ~20%
-> AP enabled again -> CPU ~4%
-> AP + WWAN + Mesh -> CPU ~5%
!!! -> disabled everything (AP, WWAN, Mesh) -> CPU 15-25%
-> enabled only one AP, WWAN or Mesh -> CPU ~5%
If rssileds is disabled at boot, high CPU load doesnt occur.
top always shows /usr/sbin/rssileds 2% CPU
-> AP enabled -> 0% sys
!!! -> AP disabled -> 14% sys
top AP disabled:
-> CPU: 4% usr 14% sys 0% nic 81% idle 0% io 0% irq 0% sirq
The text was updated successfully, but these errors were encountered:
everloop2:
see: [[https://github.com/freifunk-berlin/falter-packages/issues/142|CPE210 high cpu load bug still present
]]
Device problem occurs on:
ath79: CPE2xx, CPE5xx, maybe a major - think other devices too.
OpenWrt 19.07 - Steps to reproduce:
Bug is reproducible:
(for measurement did logout LuCI, then ssh & top)
Freifunk images -> after FFwizard+reboot -> CPU ~35%
-> set rssi (default: wlan0) to wlan0-dhcp2 or wlan0-mesh-2 in /etc/config/system -> CPU ~5%
Openwrt stock (19.07.7), firstboot, wifi:
-> AP disabled (default setting) -> CPU ~2%
-> AP enabled -> CPU ~4%
!!! -> AP disabled again -> CPU ~20%
-> AP enabled again -> CPU ~4%
-> AP + WWAN + Mesh -> CPU ~5%
!!! -> disabled everything (AP, WWAN, Mesh) -> CPU 15-25%
-> enabled only one AP, WWAN or Mesh -> CPU ~5%
If rssileds is disabled at boot, high CPU load doesnt occur.
top always shows /usr/sbin/rssileds 2% CPU
-> AP enabled -> 0% sys
!!! -> AP disabled -> 14% sys
top AP disabled:
-> CPU: 4% usr 14% sys 0% nic 81% idle 0% io 0% irq 0% sirq
The text was updated successfully, but these errors were encountered: