OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Packages
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version openwrt-19.07
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Dawid Wróbel - 27.01.2021

FS#3598 - Trival Relay (trelay) should set up the relayed port into promiscuous mode

Supply the following if possible:
- Device problem occurs on
VirtIO NIC - Software versions of OpenWrt/LEDE release, packages, etc.
OpenWrt 19.07.6 r11278
kmod-trelay - 4.14.215+0.1-2

- Steps to reproduce
Set up trival relay, /etc/config/trelay:

config trelay
option enabled 1
option dev1 eth0
option dev2 wlan0

The relay works only if eth0 is put in promiscuous mode. This can be easily handled by updating /etc/init.d/trelay to set it up automatically:

ip link set dev “$dev1” up
ip link set dev “$dev1” promisc on
ip link set dev “$dev2” up


Dawid Wróbel commented on 27.01.2021 03:24

(meant "relayed interface" in the subject line)

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing