OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Medium
  • Priority Very Low
  • Reported Version openwrt-19.07
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Sergey - 09.01.2021

FS#3566 - dlink 620 failsafe not reached

- Device problem occurs on: D-Link DIR-620 Rev A1
- Software versions of OpenWrt/LEDE release : 19.07.5

- Steps to reproduce:

1) enter the failsafe mode accordingly to instruction
Note that button became blinking too fast.

2) Try to connect via LAN.

Expected result: notebook’s eth will obtain ip from

Actual result:

- no ip address is obtained. Router still unreachable.
– Led is still blinking frequently (maybe OK).

More information: unreachable mode was obtained after playing around with relayd packet and config router to repeater mode accordingly to instruction

Sven Roederer commented on 09.06.2021 22:36

As far as I know there is no DHCP-Server enabled in failsafe-mode at all. So you have to assign an IP_address manually to your notebook, e.g. Then you should be able to SSH to the routers address (


Available keyboard shortcuts


Task Details

Task Editing