- Status Unconfirmed
- Percent Complete
- Task Type Bug Report
- Category Base system
- Assigned To No-one
- Operating System All
- Severity Medium
- Priority Very Low
- Reported Version Trunk
- Due in Version Undecided
-
Due Date
Undecided
- Private
FS#3560 - bcm47xx: Latest Snapshot fails to boot on NETGEAR R6200
After flashing the latest snapshot I noticed the device wouldn’t lease out IPs
when watching the serial console I found these errors and it’d hang on starting program
The only error before was “Checksum too long”
These are the main two partitions of the device
0×000000000000-0×000000040000 : “boot”
0×000000040000-0x000000f40000 : “firmware”
So I assume whatever is placed in “boot” is too large.
CFE for R6200 version: v1.0.1 Build Date: Fri May 11 13:46:43 CST 2012 Init Arena Init Devs. Boot partition size = 262144(0x40000) Found an ST compatible serial flash with 256 64KB blocks; total size 16MB et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 2010.09.30.0 CPU type 0x19740: 480MHz Tot mem: 131072 KBytes Device eth0: hwaddr 84-1B-5E-F5-37-41, ipaddr 192.168.1.1, mask 255.255.255.0 gateway not set, nameserver not set **too long file.** **LZMA boot failed** Loader:raw Filesys:raw Dev:flash0.os File: Options:(null) Loading: .. 3816 bytes read Entry at 0x80001000 Closing network. Starting program at 0x80001000
I also just noticed this warning when flashing from OEM to OpenWrt firmware,
snapshot dated Sat Jan 9 00:07:49 2021.