OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Kernel
  • Assigned To No-one
  • Operating System All
  • Severity Medium
  • Priority Very Low
  • Reported Version openwrt-19.07
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by fsdg fgergfdsd - 15.12.2020

FS#3515 - pcduino3 ethernet can't work

Supply the following if possible:
- Device problem occurs on pcduino3 nano - Software versions of OpenWrt/LEDE release, packages, etc. openwrt-19.07.5-sunxi-cortexa7-sun7i-a20-pcduino3-squashfs-sdcard.img - Steps to reproduce dd to tf card, insert and boot

boot message
[ 3.489541] sun7i-dwmac 1c50000.ethernet: Failed to reset the dma
[ 3.495647] sun7i-dwmac 1c50000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
[ 3.504445] sun7i-dwmac 1c50000.ethernet eth0: stmmac_open: Hw setup failed

fsdg fgergfdsd commented on 09.01.2021 09:47

after days research, i found the offical pcduino3 image is NOT adapted to pcduino3 nano. the network device of nano is Realtek RTL8211E which is not supported by the image.

so you can't use this image if you are using a nano version of pcduino3

however, pcduino3 nano are supported by upstream very good, i have successfully brought it up with some changes. It's easy to build a pcduino3 nano specific image, i will paste the patch here later.


Available keyboard shortcuts


Task Details

Task Editing