You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Followed online procedure found (copy image to SD card, touch special file, login via telnet on stock firmware, write image, reboot device) to flash OpenWRT.
After flash, device "seems" stuck dead (all leds are on, wired network irresponsive, no WiFi AP detected).
I have opened the device, soldered the serial console pins and accessere via serial console.
Device is actually booting perfectly, but both wired and wifi are not accessible.
I have WiFi enabled by setting "disabled = 0" in /etc/config/wireless to OpenWrt AP
I have Wired enabled by adding "option iface "eth0"" to the "lan" interface in /etc/config/network
Device now works great
Without these two changes, the device is as good as dead.
This is a peculiar device: only 1 ethernet port and 2.4Ghz Wifi. My guess something is wrong in the vlan/bridge/switch settings?
I hope a fix can be commited somehow so that future users do not end up with a dead-like device.
The text was updated successfully, but these errors were encountered:
In 19.07, the device is set up with:
ucidef_set_interface_lan "eth0.1"
It would be interesting how your /etc/config/network looked after flashing (and what exactly you changed there). Maybe you can reconstruct without having to flash again?
gardiol:
Just flashed 19.07.4 on Kingston MLWG2.
Followed online procedure found (copy image to SD card, touch special file, login via telnet on stock firmware, write image, reboot device) to flash OpenWRT.
After flash, device "seems" stuck dead (all leds are on, wired network irresponsive, no WiFi AP detected).
I have opened the device, soldered the serial console pins and accessere via serial console.
Device is actually booting perfectly, but both wired and wifi are not accessible.
I have WiFi enabled by setting "disabled = 0" in /etc/config/wireless to OpenWrt AP
I have Wired enabled by adding "option iface "eth0"" to the "lan" interface in /etc/config/network
Device now works great
Without these two changes, the device is as good as dead.
This is a peculiar device: only 1 ethernet port and 2.4Ghz Wifi. My guess something is wrong in the vlan/bridge/switch settings?
I hope a fix can be commited somehow so that future users do not end up with a dead-like device.
The text was updated successfully, but these errors were encountered: