You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Having any key pressed during the boot leads to failsafe in master branch always.
Buffalo WZR-HP-G300NH has a couple of sliding toggles (ON/OFF, AUTO/ON/OFF), which will have some GPIO key pressed always. After a commit 174ff7d failsafe is being triggered always.
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[ 4.381922] eth0: link up (1000Mbps/Full duplex)
[ 4.386636] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 4.393655] IPv6: ADDRCONF(NETDEV_CHANGE): eth0.1: link becomes ready
failsafe button BTN_6 was pressed -
failsafe -
The text was updated successfully, but these errors were encountered:
msandber:
Having any key pressed during the boot leads to failsafe in master branch always.
Buffalo WZR-HP-G300NH has a couple of sliding toggles (ON/OFF, AUTO/ON/OFF), which will have some GPIO key pressed always. After a commit 174ff7d failsafe is being triggered always.
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[ 4.381922] eth0: link up (1000Mbps/Full duplex)
[ 4.386636] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 4.393655] IPv6: ADDRCONF(NETDEV_CHANGE): eth0.1: link becomes ready
failsafe button BTN_6 was pressed -
failsafe -
The text was updated successfully, but these errors were encountered: