You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Software versions of OpenWrt/LEDE release, packages, etc.
OpenWrt 19.07.2, r10947-65030d81f3
miniupnpd - 2.1.20191006-4
I have both native IPv6 (wan_6 virtual interface from pppoe) and 6to4. I need 6to4 to connect to other 6to4 peers which is faster than native IPv6 (and sometimes native IPv6 cannot reach 6to4). /var/etc/miniupnpd.conf generated by /etc/init.d/miniupnpd uses 6to4 instead of native IPv6, the file contains the following lines
ext_ifname=pppoe-wan
ext_ifname6=6to4-wan6
I think it's better to use native IPv6 interface by default.
Additionally, is it possible to add ipv6_disable option to the config? Buggy UPnP clients sometimes put IPv6 address in a IPv4 port mapping request, I'd like to check if disabling IPv6 UPnP would fix it, this problem is mentioned in miniupnp/miniupnp#408
The text was updated successfully, but these errors were encountered:
fvc:
I have both native IPv6 (wan_6 virtual interface from pppoe) and 6to4. I need 6to4 to connect to other 6to4 peers which is faster than native IPv6 (and sometimes native IPv6 cannot reach 6to4). /var/etc/miniupnpd.conf generated by /etc/init.d/miniupnpd uses 6to4 instead of native IPv6, the file contains the following lines
ext_ifname=pppoe-wan
ext_ifname6=6to4-wan6
I think it's better to use native IPv6 interface by default.
Additionally, is it possible to add ipv6_disable option to the config? Buggy UPnP clients sometimes put IPv6 address in a IPv4 port mapping request, I'd like to check if disabling IPv6 UPnP would fix it, this problem is mentioned in miniupnp/miniupnp#408
The text was updated successfully, but these errors were encountered: