OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version openwrt-19.07
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by fv - 16.05.2020

FS#3100 - miniupnpd.conf generated by /etc/init.d/miniupnpd uses 6to4 instead of native IPv6 interface

- Software versions of OpenWrt/LEDE release, packages, etc.

  • OpenWrt 19.07.2, r10947-65030d81f3
  • miniupnpd - 2.1.20191006-4

I have both native IPv6 (wan_6 virtual interface from pppoe) and 6to4. I need 6to4 to connect to other 6to4 peers which is faster than native IPv6 (and sometimes native IPv6 cannot reach 6to4). /var/etc/miniupnpd.conf generated by /etc/init.d/miniupnpd uses 6to4 instead of native IPv6, the file contains the following lines


I think it’s better to use native IPv6 interface by default.
Additionally, is it possible to add ipv6_disable option to the config? Buggy UPnP clients sometimes put IPv6 address in a IPv4 port mapping request, I’d like to check if disabling IPv6 UPnP would fix it, this problem is mentioned in


Available keyboard shortcuts


Task Details

Task Editing