New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
FS#3080 - ramips/mt7621 Netgear R6220 WIFI 5 GHz issue #8618
Comments
TBeckler: going back to my own compilation based on openwrt 18.06.01
|
adrianschmutzler: Typically, the bad blocks are "normal" with NAND devices, and not inherently related to WiFi issues. However, I remotely remember that there have been issues with partition alignment when bad blocks existed for these Netgear devices, and then your calibration would possibly be read from the wrong location. Are your MAC addresses correct (as they might come from calibration data, too)? |
TBeckler: Thank you for your reply.
I think i might be on the wrong track, as
Any inputs for additional logs or tests are apprechiated. Btw. is this the correct place to address this issue? Or should it be placed on [[https://github.com/openwrt/mt76/issues|github/openwrt/mt76]]? Why are there two places? |
TBeckler: Any comments? Could this issue be related to [[https://github.com/openwrt/mt76/issues/450|Packets dropped on mt7615 for A-MSDU transmissions]]? |
TBeckler: Pardon, I missed an important information. Issue only observed with relayd. think this issue can be closed, as this problem is reported at FS#2816 - Poor upload speed with Relayd and Mediatek SoCs |
TBeckler:
I am using a Netgear R6220 router. My router has one "bad erase block"
[ 2.859177] Scanning device for bad blocks
[ 2.952205] Bad eraseblock 361 at 0x000002d20000
[ 3.116833] 6 fixed-partitions partitions found on MTD device MT7621-NAND
Every test is done with default settings. For me it is easier to debug this issue with openwrt in station mode, but it applies to AccessPoint/Master as well.
====Comarison of OpenWrt 18.06.08 and 19.07.02====
Resource is busy
====My guess/conclusion is that ====
Attached is the mtd4.bin (factory). I don't know if this helps for this issue.
======OpenWrt 18.06.08======
WIFI 5 GHz operation "normal". Means I can use any channel in 5 GHz and get good performance/throughput.
Channel 36
TX ~80Mbit/s
RX ~95Mbit/s
Channel 124
TX ~80Mbit/s
RX ~95Mbit/s
iw --debug phy phy1 info
phy phy1
max # scan SSIDs: 4
max scan IEs length: 2247 bytes
max # sched scan SSIDs: 0
max # match sets: 0
max # scan plans: 1
max scan plan interval: -1
max scan plan iterations: 0
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Available Antennas: TX 0x3 RX 0x3
Configured Antennas: TX 0x3 RX 0x3
Supported interface modes:
* IBSS
* managed
* AP
* AP/VLAN
* monitor
* mesh point
Band 2:
Capabilities: 0x1ff
RX LDPC
HT20/HT40
SM Power Save disabled
RX Greenfield
RX HT20 SGI
RX HT40 SGI
TX STBC
RX STBC 1-stream
Max AMSDU length: 3839 bytes
No DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 4 usec (0x05)
HT TX/RX MCS rate indexes supported: 0-15
VHT Capabilities (0x018001b0):
Max MPDU length: 3895
Supported Channel Width: neither 160 nor 80+80
RX LDPC
short GI (80 MHz)
TX STBC
VHT RX MCS set:
1 streams: MCS 0-9
2 streams: MCS 0-9
3 streams: not supported
4 streams: not supported
5 streams: not supported
6 streams: not supported
7 streams: not supported
8 streams: not supported
VHT RX highest supported: 0 Mbps
VHT TX MCS set:
1 streams: MCS 0-9
2 streams: MCS 0-9
3 streams: not supported
4 streams: not supported
5 streams: not supported
6 streams: not supported
7 streams: not supported
8 streams: not supported
VHT TX highest supported: 0 Mbps
Frequencies:
* 5180 MHz [36] (3.0 dBm)
* 5200 MHz [40] (3.0 dBm)
* 5220 MHz [44] (3.0 dBm)
* 5240 MHz [48] (3.0 dBm)
* 5260 MHz [52] (3.0 dBm) (no IR, radar detection)
* 5280 MHz [56] (3.0 dBm) (no IR, radar detection)
* 5300 MHz [60] (3.0 dBm) (no IR, radar detection)
* 5320 MHz [64] (3.0 dBm) (no IR, radar detection)
* 5500 MHz [100] (3.0 dBm) (no IR, radar detection)
* 5520 MHz [104] (3.0 dBm) (no IR, radar detection)
* 5540 MHz [108] (3.0 dBm) (no IR, radar detection)
* 5560 MHz [112] (3.0 dBm) (no IR, radar detection)
* 5580 MHz [116] (3.0 dBm) (no IR, radar detection)
* 5600 MHz [120] (3.0 dBm) (no IR, radar detection)
* 5620 MHz [124] (3.0 dBm) (no IR, radar detection)
* 5640 MHz [128] (3.0 dBm) (no IR, radar detection)
* 5660 MHz [132] (3.0 dBm) (no IR, radar detection)
* 5680 MHz [136] (3.0 dBm) (no IR, radar detection)
* 5700 MHz [140] (3.0 dBm) (no IR, radar detection)
* 5745 MHz [149] (3.0 dBm) (no IR)
* 5765 MHz [153] (3.0 dBm) (no IR)
* 5785 MHz [157] (3.0 dBm) (no IR)
* 5805 MHz [161] (3.0 dBm) (no IR)
* 5825 MHz [165] (3.0 dBm) (no IR)
valid interface combinations:
* #{ IBSS } <= 1, #{ managed, AP, mesh point } <= 8,
total <= 8, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz, 80 MHz }
root@OpenWrt:~# iw --debug wlan1 info Interface wlan1 ifindex 8 wdev 0x100000002 addr xx:xx:xx:xx:xx:xx ssid Africa_5GHz type managed wiphy 1 channel 124 (5620 MHz), width: 80 MHz, center1: 5610 MHz txpower 3.00 dBm
wifi status "radio1": { "up": true, "pending": false, "autostart": true, "disabled": false, "retry_setup_failed": false, "config": { "hwmode": "11a", "path": "pci0000:00\/0000:00:00.0\/0000:01:00.0", **"htmode": "VHT80",** "channel": "124", "country": "00", "legacy_rates": true, "disabled": false
======OpenWrt 19.07.02======Channel 36
** TX ~1.25 Mbit/s
RX ~95 Mbit/s**
Channel 124
** TX ~1.25 Mbit/s
RX ~95 Mbit/s**
root@OpenWrt:~# iw --debug phy1 info
Wiphy phy1
max # scan SSIDs: 4
max scan IEs length: 2247 bytes
max # sched scan SSIDs: 0
max # match sets: 0
max # scan plans: 1
max scan plan interval: -1
max scan plan iterations: 0
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Available Antennas: TX 0x3 RX 0x3
Configured Antennas: TX 0x3 RX 0x3
Supported interface modes:
* IBSS
* managed
* AP
* AP/VLAN
* monitor
* mesh point
Band 2:
Capabilities: 0x1ff
RX LDPC
HT20/HT40
SM Power Save disabled
RX Greenfield
RX HT20 SGI
RX HT40 SGI
TX STBC
RX STBC 1-stream
Max AMSDU length: 3839 bytes
No DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 4 usec (0x05)
HT TX/RX MCS rate indexes supported: 0-15
VHT Capabilities (0x318001b0):
Max MPDU length: 3895
Supported Channel Width: neither 160 nor 80+80
RX LDPC
short GI (80 MHz)
TX STBC
RX antenna pattern consistency
TX antenna pattern consistency
VHT RX MCS set:
1 streams: MCS 0-9
2 streams: MCS 0-9
3 streams: not supported
4 streams: not supported
5 streams: not supported
6 streams: not supported
7 streams: not supported
8 streams: not supported
VHT RX highest supported: 0 Mbps
VHT TX MCS set:
1 streams: MCS 0-9
2 streams: MCS 0-9
3 streams: not supported
4 streams: not supported
5 streams: not supported
6 streams: not supported
7 streams: not supported
8 streams: not supported
VHT TX highest supported: 0 Mbps
Frequencies:
* 5180 MHz [36] (20.0 dBm)
* 5200 MHz [40] (20.0 dBm)
* 5220 MHz [44] (20.0 dBm)
* 5240 MHz [48] (20.0 dBm)
* 5260 MHz [52] (20.0 dBm) (no IR, radar detection)
* 5280 MHz [56] (20.0 dBm) (no IR, radar detection)
* 5300 MHz [60] (20.0 dBm) (no IR, radar detection)
* 5320 MHz [64] (20.0 dBm) (no IR, radar detection)
* 5500 MHz [100] (20.0 dBm) (no IR, radar detection)
* 5520 MHz [104] (20.0 dBm) (no IR, radar detection)
* 5540 MHz [108] (20.0 dBm) (no IR, radar detection)
* 5560 MHz [112] (20.0 dBm) (no IR, radar detection)
* 5580 MHz [116] (20.0 dBm) (no IR, radar detection)
* 5600 MHz [120] (20.0 dBm) (no IR, radar detection)
* 5620 MHz [124] (20.0 dBm) (no IR, radar detection)
* 5640 MHz [128] (20.0 dBm) (no IR, radar detection)
* 5660 MHz [132] (20.0 dBm) (no IR, radar detection)
* 5680 MHz [136] (20.0 dBm) (no IR, radar detection)
* 5700 MHz [140] (20.0 dBm) (no IR, radar detection)
* 5745 MHz [149] (20.0 dBm) (no IR)
* 5765 MHz [153] (20.0 dBm) (no IR)
* 5785 MHz [157] (20.0 dBm) (no IR)
* 5805 MHz [161] (20.0 dBm) (no IR)
* 5825 MHz [165] (20.0 dBm) (no IR)
valid interface combinations:
* #{ IBSS } <= 1, #{ managed, AP, mesh point } <= 8,
total <= 8, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz, 80 MHz }
root@OpenWrt:~# iw --debug wlan1 info Interface wlan1 ifindex 9 wdev 0x100000003 addr xx:xx:xx:xx:xx:xx ssid Africa_5GHz type managed wiphy 1 channel 124 (5620 MHz), width: 80 MHz, center1: 5610 MHz txpower 20.00 dBm multicast TXQ: qsz-byt qsz-pkt flows drops marks overlmt hashcol tx-bytestx-packets 0 0 0 0 0 0 0 0 0
wifi status "radio1": { "up": false, "pending": false, "autostart": false, "disabled": false, "retry_setup_failed": false, "config": { "hwmode": "11a", "path": "pci0000:00/0000:00:00.0/0000:01:00.0", "htmode": "VHT80", "channel": "124", "country": "00", "legacy_rates": false
The text was updated successfully, but these errors were encountered: