FS#2996 - nanopi air cannot start in kernel 5.4.31 #7765
Labels
flyspray
kernel
pull request/issue with Linux kernel related changes
target/sunxi
pull request/issue for sunxi target
luckybike:
device: nanopi air
steps:
here is my system log:
U-Boot SPL 2020.01 (Apr 09 2020 - 20:09:21 +0000)
DRAM: 512 MiB
Trying to boot from MMC1
U-Boot 2020.01 (Apr 09 2020 - 20:09:21 +0000) Allwinner Technology
CPU: Allwinner H3 (SUN8I 1680)
Model: FriendlyARM NanoPi NEO
DRAM: 512 MiB
MMC: mmc@1c0f000: 0
Loading Environment from FAT... *** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: phy interface0
Error: ethernet@1c30000 address not set.
No ethernet found.
starting USB...
Bus usb@1c1a000: USB EHCI 1.00
Bus usb@1c1a400: USB OHCI 1.0
Bus usb@1c1d000: USB EHCI 1.00
Bus usb@1c1d400: USB OHCI 1.0
scanning bus usb@1c1a000 for devices... 1 USB Device(s) found
scanning bus usb@1c1a400 for devices... 1 USB Device(s) found
scanning bus usb@1c1d000 for devices... 1 USB Device(s) found
scanning bus usb@1c1d400 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
Found U-Boot script /boot.scr
377 bytes read in 2 ms (183.6 KiB/s)
Executing script at 43100000
3078032 bytes read in 142 ms (20.7 MiB/s)
19497 bytes read in 3 ms (6.2 MiB/s)
Booting kernel from Legacy Image at 42000000 ...
Image Name: ARM OpenWrt Linux-5.4.31
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3077968 Bytes = 2.9 MiB
Load Address: 40008000
Entry Point: 40008000
Verifying Checksum ... OK
Flattened Device Tree blob at 43000000
Booting using the fdt blob at 0x43000000
EHCI failed to shut down host controller.
Loading Kernel Image
Using Device Tree in place at 43000000, end 43007c28
Starting kernel ...
The text was updated successfully, but these errors were encountered: