OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by 66enligne - 23.03.2020

FS#2923 - wlan country code not applied unless interface is enabled

This true since version 18 and still true in version 19
Is probabbly generic. Seen on two different HW CF-E110 and WT3020)

Starting from a fresh install
Goto Network\wireless ⇒ the interface is disabled by default
Enter to edit the wireless interface

 Look at the possible channels, it is 1 to 11 (normal as the default country code is world)  

Goto Network\wireless - Device configuration\Advanced Settings

 Change the Country code from 00-World to FR-France

Validate the change by Save and Apply
Enter to edit the wireless interface (while the interface is still disabled)

 Look at the possible channels, it is still 1 to 11 (while the country code is FR)

We shall normally access to channel 1 to 13 with FR code.

Look like save and apply only saves and donnot apply the country code selection
But If you enable the interface, this allow the access to channels 1 to 13


Available keyboard shortcuts


Task Details

Task Editing