You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Using Openwrt 19.07.2 release;
On TP-Link c2600 & N750(wdr4300 v1.4)
Observed behavior:
Adding a static v4 route i.e 172.16.253.0 via 172.16.253.254 in the Luci Static route page succesfully adds the route, and by default appears to select the local route table. However viewing the routes list in status or via ip r s on cli does not show the entry.
Work-Around:
Ensure that a different table is selected in the 'Advanced tab' then go back in and add it to the correct appropriate route table.
Expected behaviour:
Adding a static route add's it to the system route table irrespective of needing to switch into advanced tab and select a non-default route table first.
The text was updated successfully, but these errors were encountered:
aenertia:
Using Openwrt 19.07.2 release;
On TP-Link c2600 & N750(wdr4300 v1.4)
Observed behavior:
Adding a static v4 route i.e 172.16.253.0 via 172.16.253.254 in the Luci Static route page succesfully adds the route, and by default appears to select the local route table. However viewing the routes list in status or via ip r s on cli does not show the entry.
Work-Around:
Ensure that a different table is selected in the 'Advanced tab' then go back in and add it to the correct appropriate route table.
Expected behaviour:
Adding a static route add's it to the system route table irrespective of needing to switch into advanced tab and select a non-default route table first.
The text was updated successfully, but these errors were encountered: