You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
iw phy0 info
Wiphy phy0
max # scan SSIDs: 4
max scan IEs length: 2243 bytes
max # sched scan SSIDs: 0
max # match sets: 0
max # scan plans: 1
max scan plan interval: -1
max scan plan iterations: 0
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Available Antennas: TX 0x1 RX 0x1
Configured Antennas: TX 0x1 RX 0x1
...
Frequencies:
* 5180 MHz [36] (12.0 dBm)
* 5200 MHz [40] (12.0 dBm)
* 5220 MHz [44] (11.0 dBm)
* 5240 MHz [48] (11.0 dBm)
* 5260 MHz [52] (11.0 dBm) (no IR, radar detection)
* 5280 MHz [56] (11.0 dBm) (no IR, radar detection)
* 5300 MHz [60] (11.0 dBm) (no IR, radar detection)
* 5320 MHz [64] (11.0 dBm) (no IR, radar detection)
* 5500 MHz [100] (12.0 dBm) (no IR, radar detection)
* 5520 MHz [104] (12.0 dBm) (no IR, radar detection)
* 5540 MHz [108] (12.0 dBm) (no IR, radar detection)
* 5560 MHz [112] (12.0 dBm) (no IR, radar detection)
* 5580 MHz [116] (12.0 dBm) (no IR, radar detection)
* 5600 MHz [120] (13.0 dBm) (no IR, radar detection)
* 5620 MHz [124] (13.0 dBm) (no IR, radar detection)
* 5640 MHz [128] (13.0 dBm) (no IR, radar detection)
* 5660 MHz [132] (13.0 dBm) (no IR, radar detection)
* 5680 MHz [136] (13.0 dBm) (no IR, radar detection)
* 5700 MHz [140] (13.0 dBm) (no IR, radar detection)
* 5745 MHz [149] (13.0 dBm) (no IR)
* 5765 MHz [153] (13.0 dBm) (no IR)
* 5785 MHz [157] (13.0 dBm) (no IR)
* 5805 MHz [161] (13.0 dBm) (no IR)
* 5825 MHz [165] (13.0 dBm) (no IR)
valid interface combinations:
* #{ IBSS } <= 1, #{ managed, AP, mesh point } <= 8,
total <= 8, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz, 80 MHz }
Sun Jan 19 18:41:34 2020 daemon.notice hostapd: Channel 52 (primary) not allowed for AP mode, flags: 0x97b NO-IR RADAR
Sun Jan 19 18:41:34 2020 daemon.warn hostapd: wlan0: IEEE 802.11 Configured channel (52) not found from the channel list of current mode (2) IEEE 802.11a
Sun Jan 19 18:41:34 2020 daemon.warn hostapd: wlan0: IEEE 802.11 Hardware does not support configured channel
Sun Jan 19 18:41:34 2020 daemon.err hostapd: Could not select hw_mode and channel. (-3)
The text was updated successfully, but these errors were encountered:
Thanks, that gets me up to (and including) channel 64, when setting the country to US. However channels 100 and above appear as if they are set, but the radio doesn't appear to transmit beacon frames, and all three of my laptops can't see the SSID (or join the network)
cvmiller:
Supply the following if possible:
Device problem occurs on
TP-Link Archer C2 v1 (AC750)
Software versions of OpenWrt/LEDE release, packages, etc.
OpenWrt SNAPSHOT r12040-8df14c229c / LuCI Master git-20.016.76613-0608ff0
Steps to reproduce
/etc/config/wireless
config wifi-device 'radio0'
option type 'mac80211'
option hwmode '11a'
option path 'pci0000:00/0000:00:00.0/0000:01:00.0'
option htmode 'VHT40'
option legacy_rates '0'
option channel '44'
iw phy0 info Wiphy phy0 max # scan SSIDs: 4 max scan IEs length: 2243 bytes max # sched scan SSIDs: 0 max # match sets: 0 max # scan plans: 1 max scan plan interval: -1 max scan plan iterations: 0 Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Available Antennas: TX 0x1 RX 0x1 Configured Antennas: TX 0x1 RX 0x1 ... Frequencies: * 5180 MHz [36] (12.0 dBm) * 5200 MHz [40] (12.0 dBm) * 5220 MHz [44] (11.0 dBm) * 5240 MHz [48] (11.0 dBm) * 5260 MHz [52] (11.0 dBm) (no IR, radar detection) * 5280 MHz [56] (11.0 dBm) (no IR, radar detection) * 5300 MHz [60] (11.0 dBm) (no IR, radar detection) * 5320 MHz [64] (11.0 dBm) (no IR, radar detection) * 5500 MHz [100] (12.0 dBm) (no IR, radar detection) * 5520 MHz [104] (12.0 dBm) (no IR, radar detection) * 5540 MHz [108] (12.0 dBm) (no IR, radar detection) * 5560 MHz [112] (12.0 dBm) (no IR, radar detection) * 5580 MHz [116] (12.0 dBm) (no IR, radar detection) * 5600 MHz [120] (13.0 dBm) (no IR, radar detection) * 5620 MHz [124] (13.0 dBm) (no IR, radar detection) * 5640 MHz [128] (13.0 dBm) (no IR, radar detection) * 5660 MHz [132] (13.0 dBm) (no IR, radar detection) * 5680 MHz [136] (13.0 dBm) (no IR, radar detection) * 5700 MHz [140] (13.0 dBm) (no IR, radar detection) * 5745 MHz [149] (13.0 dBm) (no IR) * 5765 MHz [153] (13.0 dBm) (no IR) * 5785 MHz [157] (13.0 dBm) (no IR) * 5805 MHz [161] (13.0 dBm) (no IR) * 5825 MHz [165] (13.0 dBm) (no IR) valid interface combinations: * #{ IBSS } <= 1, #{ managed, AP, mesh point } <= 8, total <= 8, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz, 80 MHz }
Sun Jan 19 18:41:34 2020 daemon.notice hostapd: Channel 52 (primary) not allowed for AP mode, flags: 0x97b NO-IR RADAR
Sun Jan 19 18:41:34 2020 daemon.warn hostapd: wlan0: IEEE 802.11 Configured channel (52) not found from the channel list of current mode (2) IEEE 802.11a
Sun Jan 19 18:41:34 2020 daemon.warn hostapd: wlan0: IEEE 802.11 Hardware does not support configured channel
Sun Jan 19 18:41:34 2020 daemon.err hostapd: Could not select hw_mode and channel. (-3)
The text was updated successfully, but these errors were encountered: