OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Kernel
  • Assigned To No-one
  • Operating System All
  • Severity Critical
  • Priority Very Low
  • Reported Version All
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Kamil Wu - 28.11.2019

FS#2638 - Not enough host controller resources for new device state when connecting two identical e3372h modem

After connecting the usb hub and two identical e3372h modems, receives the following error:

kern.info kernel: [ 4313.927551] usb 2-1: new SuperSpeed USB device number 2 using xhci-mtk
kern.info kernel: [ 4313.963934] hub 2-1:1.0: USB hub found
kern.info kernel: [ 4313.968328] hub 2-1:1.0: 4 ports detected
kern.info kernel: [ 4314.107232] usb 1-1: new high-speed USB device number 16 using xhci-mtk
kern.info kernel: [ 4314.309707] hub 1-1:1.0: USB hub found
kern.info kernel: [ 4314.314024] hub 1-1:1.0: 4 ports detected
kern.err kernel: [ 4315.449126] usb 1-1-port2: Cannot enable. Maybe the USB cable is bad?
kern.info kernel: [ 4323.227134] usb 1-1.1: new high-speed USB device number 19 using xhci-mtk
kern.info kernel: [ 4323.359684] usb-storage 1-1.1:1.0: USB Mass Storage device detected
kern.info kernel: [ 4323.366475] scsi host3: usb-storage 1-1.1:1.0
kern.info kernel: [ 4323.667042] usb 1-1.4: new high-speed USB device number 20 using xhci-mtk
kern.warn kernel: [ 4323.799302] usb 1-1.4: Not enough host controller resources for new device state.
kern.err kernel: [ 4323.806875] usb 1-1.4: can't set config #1, error -12
kern.info kernel: [ 4324.317141] usb 2-1: USB disconnect, device number 2
kern.notice kernel: [ 4324.428273] scsi 3:0:0:0: CD-ROM            HUAWEI   Mass Storage     2.31 PQ: 0 ANSI: 2
kern.notice kernel: [ 4324.441876] scsi 3:0:0:1: Direct-Access     HUAWEI   TF CARD Storage  2.31 PQ: 0 ANSI: 2
kern.notice kernel: [ 4324.469348] sd 3:0:0:1: [sdb] Attached SCSI removable disk
kern.info kernel: [ 4324.667338] usb 2-1: new SuperSpeed USB device number 3 using xhci-mtk
kern.info kernel: [ 4324.703318] hub 2-1:1.0: USB hub found
kern.info kernel: [ 4324.707765] hub 2-1:1.0: 4 ports detected
kern.info kernel: [ 4324.975384] usb 1-1.1: USB disconnect, device number 19
kern.info kernel: [ 4325.377043] usb 1-1.1: new high-speed USB device number 21 using xhci-mtk
kern.warn kernel: [ 4325.508714] usb 1-1.1: Not enough host controller resources for new device state.
kern.err kernel: [ 4325.516294] usb 1-1.1: can't set config #1, error -12
kern.info kernel: [ 4332.655468] usb 1-1.4: USB disconnect, device number 20
kern.info kernel: [ 4333.567032] usb 1-1.4: new high-speed USB device number 22 using xhci-mtk
kern.info kernel: [ 4333.699727] usb-storage 1-1.4:1.0: USB Mass Storage device detected
kern.info kernel: [ 4333.706535] scsi host3: usb-storage 1-1.4:1.0
kern.info kernel: [ 4334.703592] usb 1-1.4: USB disconnect, device number 22
kern.info kernel: [ 4335.106995] usb 1-1.4: new high-speed USB device number 23 using xhci-mtk
kern.warn kernel: [ 4335.238608] usb 1-1.4: Not enough host controller resources for new device state.
kern.err kernel: [ 4335.246174] usb 1-1.4: can't set config #1, error -12
kern.info kernel: [ 4335.254656] usb 1-1.1: USB disconnect, device number 21
kern.info kernel: [ 4335.556999] usb 1-1.1: new high-speed USB device number 24 using xhci-mtk
kern.warn kernel: [ 4335.689333] usb 1-1.1: Not enough host controller resources for new device state.
kern.err kernel: [ 4335.697209] usb 1-1.1: can't set config #1, error -12
kern.info kernel: [ 4338.571247] usb 2-1: USB disconnect, device number 3
kern.info kernel: [ 4338.937429] usb 2-1: new SuperSpeed USB device number 4 using xhci-mtk
kern.info kernel: [ 4338.973068] hub 2-1:1.0: USB hub found
kern.info kernel: [ 4338.977396] hub 2-1:1.0: 4 ports detected
Kamil Wu commented on 28.11.2019 21:36

Applies to router Unielec u7621-06

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing