You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Device problem occurs on: Pogoplug Pro
a pogoplug with mini-pcie, sata, "pogoplug pro r2 12E8" on sticker
this version has afaik original u-boot and flashed with current trunk (yesterday)
after the wiki guide
U-Boot 1.1.2 (Jul 29 2010 - 19:36:07)
U-Boot code: 60D00000 -> 60D1C030 BSS: -> 60D21800
RAM Configuration:
Bank #0: 60000000 128 MB
SRAM Configuration:
64KB at 0x50000000
NAND:128 MiB
In: serial
Out: serial
Err: serial
Setting Linux mem= boot arg value
Hit any key to stop autoboot: 0
Loading from device 0: 128MiB 3,3V 8-bit (offset 0x440000)
-- Using 1bit ECC style encoding
Image Name: ARM OpenWrt Linux-4.14.145
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2979336 Bytes = 2.8 MB
Load Address: 60008000
Entry Point: 60008000
Booting image at 60500000 ...
Image Name: ARM OpenWrt Linux-4.14.145
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2979336 Bytes = 2.8 MB
Load Address: 60008000
Entry Point: 60008000
Verifying Checksum ... OK
OK
Starting kernel ...
After initial flashing after guide the reboot fails and hangs at Starting kernel
A cold reboot (disconnect powerplug) makes the unit boot
issuing a reboot from a working serial cmdline and the device hangs at Starting kernel (again)
russell:
Supply the following if possible:
CloudEngines Pogoplug v3
# cat /etc/openwrt_release
DISTRIB_ID='OpenWrt'
DISTRIB_RELEASE='SNAPSHOT'
DISTRIB_REVISION='r11027-f39f4b2f6d'
DISTRIB_TARGET='oxnas/ox820'
DISTRIB_ARCH='arm_mpcore'
DISTRIB_DESCRIPTION='OpenWrt SNAPSHOT r11027-f39f4b2f6d'
DISTRIB_TAINTS='no-all busybox'
When the device reboots with power on, I get a bootlog like this:
root@pogoplug:/# reboot
root@pogoplug:/# [ 58.722024] reboot: Restarting system
U-Boot SPL 2013.10 (Apr 27 2014 - 19:08:27)
Boot device: NAND
Attempting to set PLLA to 800 MHz ...
plla_ctrl0 : 0000030a
plla_ctrl1 : 00400000
plla_ctrl2 : 007f0068
plla_ctrl3 : 00000193
PLLA Set
U-Boot 2013.10-tld-3 (May 15 2014 - 14:54:14) for OXNAS
DRAM: 128 MiB
NAND: 128 MiB
In: serial
Out: serial
Err: serial
Net:
Led: GREEN
mii0
Main Loop
Hit any key to stop autoboot: 0
Loading from nand0, offset 0x440000
Image Name: ARM OpenWrt Linux-4.14.143
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3057200 Bytes = 2.9 MiB
Load Address: 60008000
Entry Point: 60008000
Booting kernel from Legacy Image at 60500000 ...
Image Name: ARM OpenWrt Linux-4.14.143
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3057200 Bytes = 2.9 MiB
Load Address: 60008000
Entry Point: 60008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
Led: GREEN
Starting kernel ...
and hangs there, can't connect to it over the network, so it doesn't seem like just a serial problem.
From a cold start (power cycle), the bootlog looks like this:
U-Boot SPL 2013.10 (Apr 27 2014 - 19:08:27)
Boot device: NAND
Attempting to set PLLA to 800 MHz ...
plla_ctrl0 : 0000030a
plla_ctrl1 : 00400000
plla_ctrl2 : 007f0068
plla_ctrl3 : 00000193
PLLA Set
U-Boot 2013.10-tld-3 (May 15 2014 - 14:54:14) for OXNAS
DRAM: 128 MiB
NAND: 128 MiB
In: serial
Out: serial
Err: serial
Net:
Led: GREEN
mii0
Main Loop
Hit any key to stop autoboot: 0
Loading from nand0, offset 0x440000
Image Name: ARM OpenWrt Linux-4.14.143
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3057200 Bytes = 2.9 MiB
Load Address: 60008000
Entry Point: 60008000
Booting kernel from Legacy Image at 60500000 ...
Image Name: ARM OpenWrt Linux-4.14.143
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3057200 Bytes = 2.9 MiB
Load Address: 60008000
Entry Point: 60008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
Led: GREEN
Starting kernel ...
[ 0.000000] Booting Linux on physical CPU 0x0
[ 0.000000] Linux version 4.14.143 (openwrt@hawg) (gcc version 7.4.0 (OpenWrt GCC 7.4.0 r8984-6ba58b7b02)) #0 SMP Mon Sep 16 06:37:06 2019
[ 0.000000] CPU: ARMv6-compatible processor [410fb025] revision 5 (ARMv7), cr=00c5787d
[ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
[ 0.000000] OF: fdt: Machine model: Cloud Engines PogoPlug Series 3
[...]
and it continues to boot normally. Up until recently (10561-gff7909f69e) reboots would just hang (see also https://bugs.openwrt.org/index.php?do=details&task_id=1711), so this is an improvement, but still not fully working.
The text was updated successfully, but these errors were encountered: