OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity High
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by workflowsguy - 16.07.2019

FS#2390 - Issues with PowerLAN devices

Since switching my WNDR3700v1 from Netgear’s firmware to OpenWrt 18.06.2 r7676-cddd7b4c77, I am experiencing the following issues:

1) PowerLAN adapters and network devices connected through it are only seen by the router if the first PowerLAN adapter is connected through a crossover cable. With the manufacturer’s firmware, it was possible to connect the adapter by standard ethernet cable.

2) A printer connected through PowerLAN does not get assigned an IP4 network address, even though I have defined a static address for it in the DHCP section of OpenWrt; (it does get an IPv6 address though). The missing IP4 network address prevents the scanner part of the printer from sending scans to a network folder on my NAS connected through ethernet cable to the router. This issue also did not exist with the original Netgear firmware.



Available keyboard shortcuts


Task Details

Task Editing