OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by gbgar - 05.03.2019

FS#2163 - New installation via OEM method on Linksys WRT1900AC v1 (mamba) fails

Trying to flash a new installation of either openWRT (openwrt-18.06.2-mvebu-cortexa9-linksys-wrt1900ac-squashfs-factory.img) or the Davidc variant (lede-mvebu-cortexa9-linksys-wrt1900ac-squashfs-factory.img)from OEM gui fails on Linksys WRT1900AC v1 with firmware version 1.1.10.187766.

To reproduce, attempt to flash either image using the Linksys gui. Go to the “Connectivity” tab. In the area labeled “Manual”, choose the image file, and click “Start”. According to the gui, the flash is successful and proceeds to restart. The power and ethernet indicators light up for a bit, then the internet flashes orange until the router reboots into the Linksys firmware.

From my research, silent failure like this indicates the flash didn’t actually succeed, but I don’t have a serial cable or much time to do further diagnosis at the moment.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing