Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

FS#2140 - Kernel hang when replace older uboot with uboot 2019 for ath79/ar71xx mips platform #6990

Open
openwrt-bot opened this issue Feb 22, 2019 · 0 comments
Labels
flyspray kernel pull request/issue with Linux kernel related changes

Comments

@openwrt-bot
Copy link

rosysong:

Below is the log:

U-Boot 2019.01-00079-g3420a6fc6e-dirty (Feb 19 2019 - 17:19:16 +0800)

Qualcomm Atheros QCA9561 ver 1 rev 0
Model: AP152 Reference Board
DRAM: 128 MiB
Loading Environment from SPI Flash... SF: Detected w25q128bv with page size 256 Bytes, erase size 4 KiB, total 16 MiB, mapped at 9f000000
*** Warning - bad CRC, using default environment

In: uart@18020000
Out: uart@18020000
Err: uart@18020000
Net:
Warning: eth@0x19000000 (eth0) using random MAC address - 56:87:3c:61:9b:50
eth0: eth@0x19000000
Hit any key to stop autoboot: 0
ap152 # bootm 0x1f060000

Booting kernel from Legacy Image at 1f060000 ...

Image Name: MIPS OpenWrt Linux-4.14.101
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1615030 Bytes = 1.5 MiB
Load Address: 80060000
Entry Point: 80060000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
[ 0.000000] Linux version 4.14.101 (xxx@xxx-PC) (gcc version 7.4.0 (OpenWrt GCC 7.4.0 r8997-488af51f81)) #0 Mon Feb 18 15:11:32 2019
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 00019750 (MIPS 74Kc)
[ 0.000000] MIPS: machine is ROSINSON WR818
[ 0.000000] SoC: Qualcomm Atheros QCA956X ver 1 rev 0
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 08000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x0000000000000000-0x0000000007ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000000000-0x0000000007ffffff]
[ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff]
[ 0.000000] random: get_random_bytes called from start_kernel+0x8c/0x474 with crng_init=0
[ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 32512
[ 0.000000] Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2
[ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes)
[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 123184K/131072K available (3777K kernel code, 150K rwdata, 912K rodata, 1232K init, 204K bss, 7888K reserved, 0K cma-reserved)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS: 51
[ 0.000000] CPU clock: 775.000 MHz
[ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 4932285024 ns
[ 0.000007] sched_clock: 32 bits at 387MHz, resolution 2ns, wraps every 5541893118ns
[ 0.008841] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216)
[ 0.075897] pid_max: default: 32768 minimum: 301
[ 0.081292] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.088805] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.100195] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.111385] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 0.118370] pinctrl core: initialized pinctrl subsystem
[ 0.125117] NET: Registered protocol family 16
[ 0.152720] clocksource: Switched to clocksource MIPS
[ 0.159331] NET: Registered protocol family 2
[ 0.164932] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.172894] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.180116] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.187461] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.194136] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.201461] NET: Registered protocol family 1
[ 0.209168] Crashlog allocated RAM at address 0x3f00000
[ 0.216385] workingset: timestamp_bits=30 max_order=15 bucket_order=0
[ 0.227688] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.234346] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.253234] io scheduler noop registered
[ 0.257682] io scheduler deadline registered (default)
[ 0.263810] ar7200-usb-phy usb-phy: phy reset is missing
[ 0.271331] pinctrl-single 1804002c.pinmux: 544 pins at pa b804002c size 68
[ 0.280201] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.288040] console [ttyS0] disabled
[ 0.292122] 18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 8, base_baud = 1562500) is a 16550A
[ 0.301943] console [ttyS0] enabled
[ 0.301943] console [ttyS0] enabled
[ 0.309500] bootconsole [early0] disabled
[ 0.309500] bootconsole [early0] disabled
[ 0.332542] m25p80 spi0.0: w25q128 (16384 Kbytes)
[ 0.337492] 5 fixed-partitions partitions found on MTD device spi0.0
[ 0.344060] Creating 5 MTD partitions on "spi0.0":
[ 0.349014] 0x000000000000-0x000000040000 : "u-boot"
[ 0.354834] 0x000000040000-0x000000050000 : "u-boot-env"
[ 0.360944] 0x000000050000-0x000000060000 : "factory"
[ 0.366831] 0x000000060000-0x000000fe0000 : "firmware"
[ 0.374973] 2 uimage-fw partitions found on MTD device firmware
[ 0.381090] Creating 2 MTD partitions on "firmware":
[ 0.386258] 0x000000000000-0x000000190000 : "kernel"
[ 0.392027] 0x000000190000-0x000000f80000 : "rootfs"
[ 0.397783] mtd: device 5 (rootfs) set to be root filesystem
[ 0.403703] 1 squashfs-split partitions found on MTD device rootfs
[ 0.410095] 0x000000440000-0x000000f80000 : "rootfs_data"
[ 0.416295] 0x000000ff0000-0x000001000000 : "art"
[ 0.422691] libphy: Fixed MDIO Bus: probed
[ 0.763078] libphy: ag71xx_mdio: probed
[ 0.770036] switch0: Atheros AR8337 rev. 2 switch registered on mdio-bus.0
[ 1.424526] ag71xx 19000000.eth: invalid MAC address, using random address
[ 1.763882] ag71xx 19000000.eth: connected to PHY at mdio-bus.0:00 [uid=004dd036, driver=Atheros AR8216/AR8236/AR8316]
[ 1.775479] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:SGMII
[ 1.783515] NET: Registered protocol family 10
[ 1.791439] Segment Routing with IPv6
[ 1.795358] NET: Registered protocol family 17
[ 1.799984] 8021q: 802.1Q VLAN Support v1.8
[ 1.810014] VFS: Mounted root (squashfs filesystem) readonly on device 31:5.
[ 1.824049] Freeing unused kernel memory: 1232K
[ 1.828729] This architecture does not have kernel memory protection.

By the way, for the ath79 target(linux-4.14) after I enable CONFIG_MIPS32R2_IRQ_VI options, it works fine.
But still hang in ar71xx(linux-4.9.158).

@aparcar aparcar added the kernel pull request/issue with Linux kernel related changes label Feb 22, 2022
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
flyspray kernel pull request/issue with Linux kernel related changes
Projects
None yet
Development

No branches or pull requests

2 participants