OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity High
  • Priority Very Low
  • Reported Version openwrt-18.06
  • Due in Version Undecided
  • Due Date Undecided
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by Fabian - 10.02.2019

FS#2114 - WG302v1 (ixp4xx-generic) LAN (eth0) start and then stop at boot

Hello

Device: Netgear WG302v1 ixp4xx
FW: 18.06.1 & 18.06.2

Device problem occurs at boot.
During boot LAN (eth0) become ready (LEDs are lit) and then stop after ~2 or ~3 seconds (LEDs are off).
WAN (radio) interface seems working but Ethernet (eth0) is down.
Impossible to get it up because ifconfig up have no effect.

No packages are installed only stock zImage and Shashfs.

With 18.06.1 (default config, IP after flashing) :
OpenWRT say that ethO is up and ready but eth0 and LEDs are off.
Impossible to reach LuCi or ping a computer with IP 192.168.1.10 (connected through serial console on device)
At boot eth0 stay up sometimes ~ 1 of 20.

With 18.06.2 (default config, IP after flashing) :
It seems there are more information during boot.
Kernel is reporting that br-lan: port 1(eth0) entered disabled stat
ifconfig up/down has no effect.

Step to reproduce:
Flash & boot.

You can find included as attached file 18.06.1 & 18.06.2 dmesg boot log.

Kind Regards

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing