You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Yes, I've connectivity issues. In 1 minute or less after the connection with ap is established it alwayse look the same, rx bitrate goes to 1.0 MBit and I'm unable even to send ping to ap.
I've did some research and I've found out that problem is with 2.4GHz wifi module. Second module (5G) is working OK.
Right now I've installed snapshoot 30.01.2019 and it is working only on 11g band. After 4 days and 21h it is working stable. But it has only 54Mbps. Every time when I enable N band I lost connection. This mean connection to AP is established, but I'm unable to send anything.
My current configuration:
config wifi-device 'radio0'
option type 'mac80211'
option channel '10'
option hwmode '11g'
option path 'pci0000:00/0000:00:00.0/0000:01:00.0'
option greenfield '0'
option diversity '1'
option powersave '0'
option txpower '30'
option country 'US'
option log_level '8'
option disabled '0'
option legacy_rates '0'
option noscan '1'
sumsu:
Device: TP-LINK RE350 v1
OpenWRT: 18.06-SNAPSHOOT 22.01.2019
Wireless setup:
Problem and solution:
AP and STA works on Channel 1. STA few seconds after connection to upstream AP losts RX stream.
The text was updated successfully, but these errors were encountered: