You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
driver: ath10k_pci
version: 4.9.120
firmware-version: 10.2.4-1.0-00037
expansion-rom-version:
bus-info: 0000:00:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no
hujkis:
[ 9.959484] ath10k_pci 0000:00:00.0: pci irq legacy oper_irq_mode 1 irq_mode 0 reset_mode 0
[ 10.237100] ath10k_pci 0000:00:00.0: Direct firmware load for ath10k/pre-cal-pci-0000:00:00.0.bin failed with error -2
[ 10.248191] ath10k_pci 0000:00:00.0: Falling back to user helper
[ 10.408785] firmware ath10k!pre-cal-pci-0000:00:00.0.bin: firmware_loading_store: map pages failed
[ 10.632975] ath10k_pci 0000:00:00.0: Direct firmware load for ath10k/QCA988X/hw2.0/firmware-6.bin failed with error -2
[ 10.644068] ath10k_pci 0000:00:00.0: Falling back to user helper
[ 10.711405] firmware ath10k!QCA988X!hw2.0!firmware-6.bin: firmware_loading_store: map pages failed
[ 11.003394] ath10k_pci 0000:00:00.0: qca988x hw2.0 target 0x4100016c chip_id 0x043202ff sub 0000:0000
[ 11.012951] ath10k_pci 0000:00:00.0: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
[ 11.025957] ath10k_pci 0000:00:00.0: firmware ver 10.2.4-1.0-00037 api 5 features no-p2p,raw-mode,mfp,allows-mesh-bcast crc32 a4a52adb
[ 11.071246] ath10k_pci 0000:00:00.0: Direct firmware load for ath10k/QCA988X/hw2.0/board-2.bin failed with error -2
[ 11.082056] ath10k_pci 0000:00:00.0: Falling back to user helper
[ 11.150077] firmware ath10k!QCA988X!hw2.0!board-2.bin: firmware_loading_store: map pages failed
Archer C7 v4
OpenWrt 18.06.1, r7258-5eb055306f
opkg list-installed | grep ath
ath10k-firmware-qca988x - 2018-05-12-952afa49-1
kmod-ath - 4.9.120+2017-11-01-9
kmod-ath10k - 4.9.120+2017-11-01-9
kmod-ath9k - 4.9.120+2017-11-01-9
kmod-ath9k-common - 4.9.120+2017-11-01-9
ethtool -i wlan0
driver: ath10k_pci
version: 4.9.120
firmware-version: 10.2.4-1.0-00037
expansion-rom-version:
bus-info: 0000:00:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no
luci:
Qualcomm Atheros QCA9880 802.11nac
Channel: ? (5.000 GHz) | Bitrate: ? Mbit/s
0%
SSID: xxxx | Mode: Master
Wireless is not associated
config wifi-device 'radio0'
option type 'mac80211'
option hwmode '11a'
option path 'pci0000:00/0000:00:00.0'
option htmode 'VHT80'
option legacy_rates '1'
option country 'CZ'
option channel 'auto'
config wifi-iface 'default_radio0'
option device 'radio0'
option network 'lan'
option mode 'ap'
option hidden '1'
option encryption 'psk2'
option key 'xxxxxxxxx'
option ssid 'xxxx'
/lib/firmware# tree
.
├── ath10k
│ ├── QCA988X
│ │ └── hw2.0
│ │ ├── board.bin
│ │ └── firmware-5.bin
│ └── cal-pci-0000:00:00.0.bin
└── regulatory.db
lspci -v
00:00.0 Network controller: Qualcomm Atheros QCA986x/988x 802.11ac Wireless Network Adapter
Flags: bus master, fast devsel, latency 0, IRQ 40
Memory at 12000000 (64-bit, non-prefetchable) [size=2M]
[virtual] Expansion ROM at 12200000 [disabled] [size=64K]
Capabilities: [40] Power Management version 2
Capabilities: [50] MSI: Enable- Count=1/8 Maskable+ 64bit-
Capabilities: [70] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Virtual Channel
Capabilities: [160] Device Serial Number 00-00-00-00-00-00-00-00
Kernel driver in use: ath10k_pci
lspci: Unable to load libkmod resources: error -12
Sometimes, the 5ghz works after reboot, despite the fw error dmesg messages.
I've also tried a snapshot from 4 days ago, with the same results.
The text was updated successfully, but these errors were encountered: