OpenWrt/LEDE Project

  • Status Unconfirmed
  • Percent Complete
    0%
  • Task Type Bug Report
  • Category Base system
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Trunk
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
  • Private
Attached to Project: OpenWrt/LEDE Project
Opened by nopnopnop - 31.10.2018

FS#1920 - ath10k: pdev param 0 not supported by firmware

device: Archer C7 v2.0
OpenWrt revision: OpenWrt SNAPSHOT r8385-374e646

1 compile and flash
2 bring up the 5 GHz wifi interface
3 check the dmesg output
4 the wifi may or may not start when enabled

The CPU usage is pretty high (close to 80-90% used by sirq) when transferring 50-80 Mbps of data from the Internet. Packets are lost sometimes over the wifi and the wifi appears unstable overall. This packet loss doesn’t occur when pinging directly from the router.

The router is on a 5 GHz channel which is free.

I had to push the wifi on/off switch to get the wifi to work.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing