You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Software versions of OpenWrt/LEDE release, packages, etc.
Steps to reproduce
I run a openwrt 18.06.1 on Lenovo Y1 with both IPv4 and IPv6, and I tried to disable the DHCPv6 on LAN to get a IPv6-Only network for testing, but it's failed. And it's successed to disable the DHCPv6 on lede 17.0.1.6
Steps to produce:
1、Navigate to Network --> Interfaces, choose LAN --> DHCP Server tab page, check the "ignore interface"
2、Connect to WIFI to obtain the IP addresses using a iPhone, you'll see only IPv6 address is obtained.
3、Access a IPv4 site using browser, it's successed, check the IP addresses again, you'll see the device obtians a IPv4 address again.
4、Try to disalbe "Dynamic DHCP" on the Advanced Settings tab page, and then repeat the steps #1 ~ #3, it doesn't work too.
The text was updated successfully, but these errors were encountered:
gushengyuan:
Supply the following if possible:
I run a openwrt 18.06.1 on Lenovo Y1 with both IPv4 and IPv6, and I tried to disable the DHCPv6 on LAN to get a IPv6-Only network for testing, but it's failed. And it's successed to disable the DHCPv6 on lede 17.0.1.6
Steps to produce:
1、Navigate to Network --> Interfaces, choose LAN --> DHCP Server tab page, check the "ignore interface"
2、Connect to WIFI to obtain the IP addresses using a iPhone, you'll see only IPv6 address is obtained.
3、Access a IPv4 site using browser, it's successed, check the IP addresses again, you'll see the device obtians a IPv4 address again.
4、Try to disalbe "Dynamic DHCP" on the Advanced Settings tab page, and then repeat the steps #1 ~ #3, it doesn't work too.
The text was updated successfully, but these errors were encountered: