You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
On a few latest master builds for TP-Link MR-3040 v2 sysupgrade doesn't work.
I flash a sysupgrade image using "sysupgrade" command. No error messsage appears. The device disconnects and
then reboots after a while. But the Openwrt version stays the old one.
If I flash an image using "mtd write", it works as intended.
There must be a bug in "sysupgrade". I can't connect serial to this device at the moment, and there is no other way to catch some error message if there is one.
Probably it is related to low RAM, but it is not that low. It is enough for mtd flash.
The text was updated successfully, but these errors were encountered:
Pilot6:
On a few latest master builds for TP-Link MR-3040 v2 sysupgrade doesn't work.
I flash a sysupgrade image using "sysupgrade" command. No error messsage appears. The device disconnects and
then reboots after a while. But the Openwrt version stays the old one.
If I flash an image using "mtd write", it works as intended.
There must be a bug in "sysupgrade". I can't connect serial to this device at the moment, and there is no other way to catch some error message if there is one.
Probably it is related to low RAM, but it is not that low. It is enough for mtd flash.
The text was updated successfully, but these errors were encountered: