You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
iw dev f00 ibss join foobar 2412 key d:0:42325d294a
Usage: iw [options] dev ibss join [NOHT|HT20|HT40+|HT40-|5MHz|10MHz|80MHz] [fixed-freq] [] [beacon-interval ] [basic-rates <rate in Mbps,rate2,...>] [mcast-rate ] [key d:0:abcde]
Join the IBSS cell with the given SSID, if it doesn't exist create
it on the given frequency. When fixed frequency is requested, don't
join/create a cell on a different frequency. When a fixed BSSID is
requested use that BSSID and do not adopt another cell's BSSID even
if it has higher TSF and the same SSID. If an IBSS is created, create
it with the specified basic-rates, multicast-rate and beacon-interval.
Options:
--debug enable netlink debugging
The text was updated successfully, but these errors were encountered:
Same thing happens with built-in and external wifi. It's like the command doesn't have the option although the help clearly defines it and the very same command which works on another Linux does not work in OpenWRT. This also causes the IBSS setup to fail if I try to configure it via UCI.
jsantala:
VoCore2 / OpenWrt SNAPSHOT, r7866-8c91807
Works:
iw phy phy0 interface add f00 type ibss
ip link set up f00
iw dev f00 ibss join foobar 2412
root@tolppaB8D812x67_27402:~# iwinfo f00 info
f00 ESSID: "foobar"
Access Point: B8:D8:12:67:6B:0A
Mode: Ad-Hoc Channel: 1 (2.412 GHz)
Tx-Power: 0 dBm Link Quality: unknown/70
Signal: unknown Noise: unknown
Bit Rate: unknown
Encryption: unknown
Type: nl80211 HW Mode(s): 802.11bgn
Hardware: unknown [Generic MAC80211]
TX power offset: unknown
Frequency offset: unknown
Supports VAPs: yes PHY name: phy0
Does NOT work:
iw dev f00 ibss join foobar 2412 key d:0:42325d294a
Usage: iw [options] dev ibss join [NOHT|HT20|HT40+|HT40-|5MHz|10MHz|80MHz] [fixed-freq] [] [beacon-interval ] [basic-rates <rate in Mbps,rate2,...>] [mcast-rate ] [key d:0:abcde]
Join the IBSS cell with the given SSID, if it doesn't exist create
it on the given frequency. When fixed frequency is requested, don't
join/create a cell on a different frequency. When a fixed BSSID is
requested use that BSSID and do not adopt another cell's BSSID even
if it has higher TSF and the same SSID. If an IBSS is created, create
it with the specified basic-rates, multicast-rate and beacon-interval.
Options:
--debug enable netlink debugging
The text was updated successfully, but these errors were encountered: