You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Belkin F5D8235-4 v1 installed with lede-17.01.4-ramips-rt288x-f5d8235-v1-squashfs-sysupgrade.bin
ports 1 and 2 do not auto negotiate to 1Gbit speed, WAN port sets also to 100Mbit and all works fine
when same or additional cabling is used on ports 3 and 4 they negotiate to 1Gbit, but WAN ports stays 100Mbit and 50% packet get lost going out the WAN interface, while LAN communication works fine.
ethtool do not recognize/cannot set/check eth0 so speed and duplex cannot be forced manualy
on factory firmware with same cabling all 5 ports work fine with 1Gbit
if there is anything I can do to fix/test let me know
The text was updated successfully, but these errors were encountered:
I confirm that I have the same issue. Only LAN port 3 and 4 is working correctly, so I declares LAN port 4 as WAN and used external gigabit switch on LAN port 3.
rm245x:
Belkin F5D8235-4 v1 installed with lede-17.01.4-ramips-rt288x-f5d8235-v1-squashfs-sysupgrade.bin
ports 1 and 2 do not auto negotiate to 1Gbit speed, WAN port sets also to 100Mbit and all works fine
when same or additional cabling is used on ports 3 and 4 they negotiate to 1Gbit, but WAN ports stays 100Mbit and 50% packet get lost going out the WAN interface, while LAN communication works fine.
ethtool do not recognize/cannot set/check eth0 so speed and duplex cannot be forced manualy
on factory firmware with same cabling all 5 ports work fine with 1Gbit
if there is anything I can do to fix/test let me know
The text was updated successfully, but these errors were encountered: