You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Belkin F5D8235-4 v1
lede-17.01.4-ramips-rt288x-f5d8235-v1-squashfs-sysupgrade.bin
when ports 1 and 2 are used gigabit ports auto negotiate for 100Mbit including WAN port and all seem work fine
when the same or additional cables are plugged to ports 3 and 4 gigabit ports auto negotiate for 1Gbit (while the other stay @100Mbit) and there is huge packet loss (around 50% - probably due failed autonegotiation)
ethtool package does not recognize interfaces (e.g. eth0/1) so speed/duplex cannot be set/checked.
with same cabling all ports work fine @1GBit including provider WAN connection with factory firmware.
The text was updated successfully, but these errors were encountered:
rm245x:
Belkin F5D8235-4 v1
lede-17.01.4-ramips-rt288x-f5d8235-v1-squashfs-sysupgrade.bin
when ports 1 and 2 are used gigabit ports auto negotiate for 100Mbit including WAN port and all seem work fine
when the same or additional cables are plugged to ports 3 and 4 gigabit ports auto negotiate for 1Gbit (while the other stay @100Mbit) and there is huge packet loss (around 50% - probably due failed autonegotiation)
ethtool package does not recognize interfaces (e.g. eth0/1) so speed/duplex cannot be set/checked.
with same cabling all ports work fine @1GBit including provider WAN connection with factory firmware.
The text was updated successfully, but these errors were encountered: