You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
CPU1: Broadcom BCM47186B0 (500 MHz)
FLA1: 8 MiB (Macronix MX25L6405EMI-12G)
RAM1: 64 MiB (Micron MT47H32M16HR-3:F × 1)
WI1 chip1: Broadcom BCM47186B0
WI1 802dot11 protocols: bgn
WI1 MIMO config: 2x2:2
WI1 antenna connector: none
ETH chip1: Broadcom BCM47186B0
Switch: Broadcom BCM53125S
LAN speed: 10/100/1000
LAN ports: 4
WAN speed: 10/100/1000
WAN ports: 1
FIRMWARE FLASHED
LEDE TRUNK, THE LATEST VERSION
BUGS REPORT:
It seems after flashing the lede firmware, the brcm47xx board detection not working for this unit.
Under luci first "status" page, the "model" of the wireless router shows "unknown board" instead of the correct model number. For example, ASUS RT-N15U
When i flash back to cc15.05.1 or bb14.07, the luci will show the correct model no. of the router.
There are so many models of the brcm47xx series and several of them can not be displayed and recognized.
The text was updated successfully, but these errors were encountered:
tacuar:
DEVICE: ASUS RT-N15U
CPU1: Broadcom BCM47186B0 (500 MHz)
FLA1: 8 MiB (Macronix MX25L6405EMI-12G)
RAM1: 64 MiB (Micron MT47H32M16HR-3:F × 1)
WI1 chip1: Broadcom BCM47186B0
WI1 802dot11 protocols: bgn
WI1 MIMO config: 2x2:2
WI1 antenna connector: none
ETH chip1: Broadcom BCM47186B0
Switch: Broadcom BCM53125S
LAN speed: 10/100/1000
LAN ports: 4
WAN speed: 10/100/1000
WAN ports: 1
FIRMWARE FLASHED
LEDE TRUNK, THE LATEST VERSION
BUGS REPORT:
It seems after flashing the lede firmware, the brcm47xx board detection not working for this unit.
Under luci first "status" page, the "model" of the wireless router shows "unknown board" instead of the correct model number. For example, ASUS RT-N15U
When i flash back to cc15.05.1 or bb14.07, the luci will show the correct model no. of the router.
There are so many models of the brcm47xx series and several of them can not be displayed and recognized.
The text was updated successfully, but these errors were encountered: