You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
And restarted the device. It was expected that the monitor interface is now in HT40 mode (able to receive on HT40) and on channel 5. But in reality, the device was now on channel 1 and used a 20MHz (non-HT) channel setting:
root@LEDE:/# iw dev
phy#0
Interface mon0
ifindex 7
wdev 0x2
addr 00:11:22:33:44:55
type monitor
channel 1 (2412 MHz), width: 20 MHz (no HT), center1: 2412 MHz
txpower 20.00 dBm
The text was updated successfully, but these errors were encountered:
charlemagnelasse:
Just created a monitor interface with an WLE200NX:
config wifi-device 'radio0'
option type 'mac80211'
option channel '5'
option hwmode '11g'
option path 'pci0000:00/0000:00:02.5/0000:04:00.0'
option htmode 'HT40'
option disabled '0'
config wifi-iface
option mode 'monitor'
option device 'radio0'
option ifname 'mon0'
And restarted the device. It was expected that the monitor interface is now in HT40 mode (able to receive on HT40) and on channel 5. But in reality, the device was now on channel 1 and used a 20MHz (non-HT) channel setting:
root@LEDE:/# iw dev
phy#0
Interface mon0
ifindex 7
wdev 0x2
addr 00:11:22:33:44:55
type monitor
channel 1 (2412 MHz), width: 20 MHz (no HT), center1: 2412 MHz
txpower 20.00 dBm
The text was updated successfully, but these errors were encountered: