You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The device is BT Home Hub 5
The release is built from SNAPSHOT r4940-00e9a7a
When the router is rebooted DSL fails to sync/connect automatically
If I execute the following commands:
/etc/init.d/dsl_control stop
and then
/etc/init.d/dsl_control start
It finally syncs/connects. PPPOA however takes a long time to come up after that (over one minute, ) whilst with previous firmare releases it used to take only a few seconds.
Something changed between r4883 (the last release I have built which is working fine) and r4940. I have not built thus I do not have the releases in between the two indicated.
The text was updated successfully, but these errors were encountered:
ezplanet:
The device is BT Home Hub 5
The release is built from SNAPSHOT r4940-00e9a7a
When the router is rebooted DSL fails to sync/connect automatically
If I execute the following commands:
/etc/init.d/dsl_control stop
and then
/etc/init.d/dsl_control start
It finally syncs/connects. PPPOA however takes a long time to come up after that (over one minute, ) whilst with previous firmare releases it used to take only a few seconds.
Something changed between r4883 (the last release I have built which is working fine) and r4940. I have not built thus I do not have the releases in between the two indicated.
The text was updated successfully, but these errors were encountered: