You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
At this moment it is impossible to use the full txpower of the WN570HA1 on both bands (2,4Ghz and 5Ghz).
Possible txpower at the moment:
2,4 Ghz --->24dbm (should have at least 27dbm)
5 Ghz ---> 11 dbm or 13 dbm (can`t remember right now)
Is it possible, that the device uses an external amplifier which has to be activated via gpio settings?
openwrt12345:
Device : WAVLINK WL-WN570HA1
Firmwareversion : all (19.07.7)
At this moment it is impossible to use the full txpower of the WN570HA1 on both bands (2,4Ghz and 5Ghz).
Possible txpower at the moment:
2,4 Ghz --->24dbm (should have at least 27dbm)
5 Ghz ---> 11 dbm or 13 dbm (can`t remember right now)
Is it possible, that the device uses an external amplifier which has to be activated via gpio settings?
Referring to this post for the Asus Lyra 2200, could some sort of same method activate the amp in the WN570HA1 ?
https://forum.openwrt.org/t/asus-map-ac2200-low-transmit-receive-signal-5ghz/69005
I hope that one or two replies from more experienced users/programmers could lead us in the right direction.
Thanks in advance.
The text was updated successfully, but these errors were encountered: